Setting up your product

Connect the OmniJewel speaker bases

Connect the bare wire pairs at the end of the front and rear speaker cables to the four OmniJewel speaker base adapters:

1. Use the included screwdriver to loosen the screws on the four speaker bases
2. Connect the black and red bare wire pairs on each speaker cable to the corresponding colored connectors on the four speaker base adapters
   Tip: Insert only the metal portion of the wires into the adapters
3. Use the screwdriver to tighten the terminals on the adapters to hold the wires in place
4. Fit the adapters flush to the bottom of the four speakers
   Tip: The wires should be at the back of the speakers
5. Use the screwdriver to tighten the screw in the center of the adapters to secure them to the speakers.

Connect the front speakers

1. On the back of the system console, connect the front speakers cable to the 4-pin Front Speakers jack
2. Connect the center speaker cable from the center speaker to the 6-pin Front Speakers jack
3. Place the speakers:
   1. Place the left speaker to the left of the TV
   2. Place the right speaker to the right of the TV
   3. Place the center speaker above or below the center of the TV
      Tip: The left and right speakers are determined by your left and right while facing the TV

Connect the rear speakers

Using a wired connection:

If you are not using the wireless receivers, press the Teletext button on the remote (below the Blue button) to proceed.

Using a wireless connection:

1. Connect the rear speaker cables from the rear speakers to the wireless rear speaker receivers
2. Set the switch on one wireless receiver to L (for the rear left speaker) and set the switch on the other recevier to R (for the rear right speaker)
   Tip: The left and right speakers are determined by your left and right while facing the TV
3. Connect power cords from both wireless receivers to AC (mains) outlets.

Connecting the console, bass module and remote control

1. Connect the HDMI cable from the OUT TO TV jack on the system console to your TV
2. Connect the power supply from the POWER jack on the system console to an AC (mains) outlet
3. Connect a power cord from the power supply to an AC (mains) outlet
4. Connect a power cord from the bass module to an AC (mains) outlet
5. Install the four batteries in the remote. Be sure to match the + and - markings on the batteries to the corresponding marks in the battery compartment

Tip: When first powering on, use the Power button on the system console since the remote might not yet be paired. Then, follow the on-screen setup instructions to pair your remote, connect other devices and program your remote.

For speaker placement suggestions, see Speaker placement and positioning.

For more information on how to run ADAPTiQ, see ADAPTiQ system setup and deactivation.

The ADAPTiQ audio calibration software, included with the system, automatically tests the acoustics of the listening area, analyzes speaker placement and tailors the sound of the system to the specific acoustics of the room.

For more info, see Connecting other devices to your system.